What is this tool used for?

Started by Windsong, May 26, 2025, 03:37:38 PM

Previous topic - Next topic

350 Rocket

It's to hold a clarinet tenon while sanding a new tenon cork to size.
Posted to the original The Clarinet Pages forum from my Power Macintosh 6100/60 using Netscape Navigatorâ„¢

Windsong

Aah, I see.  I would have to play with it a bit to fully understand the benefit, but I am glad to know its use. 
Expert bubblegum welder, and Pedler Pedler.

brigaltman

you place the tenon on the cone, hold it in place with your leg (or whatever other part of your body works) and sand the new cork down to the correct size. It's a very handy tool. I wish I had one.
SW Michigan Clarinets

mechanic

Here's another option from the Haynes Clarinet Manual by Stephan Howard.
Clamps to a bench or table.
For Phil's  " The Clarinet Pages " forum. https://clarinetpages.info/

Windsong

I keep thinking the gut holds the other end? 😄
Expert bubblegum welder, and Pedler Pedler.

windydankoff

Yes, and hopefully your arms are long enough.
BLACK • HOLE Clarinets, BIGMouthPiece for alto clarinet
https://www.windydankoff.com/black-hole-clarinets.html

Windsong

Well, I just keep thinking it would not be too difficult to implement two of these, and have them on a sliding adjustment rail to easily adjust the distance, depending upon the project.

Truthfully, I almost never sand tenon cork anymore.  I purchase tenon cork in every thickness, and use a vermeer caliper, so it is seldom necessary. When I do need to sand cork, I typically drag it, pre-installation, across the sand paper in one direction, so as to minimize the risk of tearing it. 

I know I must send the professionals among us into fits of uncontrollable laughter, but I am self taught, so...😁
Expert bubblegum welder, and Pedler Pedler.